Hi, I am working with the FPGA 5CSEMA6U23C8N. I would like to know for the HPS_Power how do I know how much power need each bank, should we specify it in the software or it's already specified in the FPGA architecture?

[SreekumarR_G_Intel]

i am not sure i followed your questions ? Are you asking how much power required for hps rails ?

Can you clarify your questions please ?

Thank you ,

Regards,

Sree

[AAyed]

Hi! thank you for your interest.

My question was how do I know how to power the banks for the hps like in the image (for the FPGA) and if possible how to know the filters to design for each power supply.

Thank you,

Regards,

Amal

[AAyed]

[AAyed]

[SreekumarR_G_Intel]

For the cyclone V , total power Estimating kindly use below link and download for cyclone V

https://www.intel.com/content/www/us/en/programmable/support/support-resources/operation-and-testing/power/pow-powerplay.html

And for the decoupling cap , here is the PDN sheet

https://www.intel.com/content/www/us/en/programmable/support/support-resources/support-centers/signal-power-integrity/power-distribution-network.html

kindly click the "Power Delivery Network (PDN) Tool 2.0 for Arria V, Stratix V, Cyclone® V, Cyclone IV, and Arria II GZ Devices (ZIP)"

Thank you ,

Regards,

Sree