- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i am not sure i followed your questions ? Are you asking how much power required for hps rails ?
Can you clarify your questions please ?
Thank you ,
Regards,
Sree
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi! thank you for your interest.
My question was how do I know how to power the banks for the hps like in the image (for the FPGA) and if possible how to know the filters to design for each power supply.
Thank you,
Regards,
Amal
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
For the cyclone V , total power Estimating kindly use below link and download for cyclone V
https://www.intel.com/content/www/us/en/programmable/support/support-resources/operation-and-testing...
And for the decoupling cap , here is the PDN sheet
https://www.intel.com/content/www/us/en/programmable/support/support-resources/support-centers/signa...
kindly click the "Power Delivery Network (PDN) Tool 2.0 for Arria V, Stratix V, Cyclone® V, Cyclone IV, and Arria II G..."
Thank you ,
Regards,
Sree

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page