kernel crashing with cyclone V soc device when both eth0 and eth1 connected

aks106 · ‎05-10-2023

JingyangTeh · ‎05-10-2023

Hi aks106

Could I get some more information regarding your setup?

Are you using a custom board or a development kit?

If you are using the development kit, are you using the GHRD on the board?

If you did any changes to the GHRD, what are the changes made?

Regards

Jingyang, Teh

aks106 · ‎05-10-2023

Hi,

We are using custom board and taken reference from GHRD.

JingyangTeh · ‎05-16-2023

Hi Aks106

Could you share what are the major changes made to the GHRD?

Do the kernel crash when only one eth is connected?

Regards

Jingyang, Teh

JingyangTeh · ‎05-22-2023

Hi Aks106

Any update on this case?

Regards

Jingyang, Teh

JingyangTeh · ‎05-25-2023

Hi

Since there are no feedback for this thread, I shall set this thread to close pending. Please login to ‘https://supporttickets.intel.com’, view details of the desire request, and post a feed/response within the next 15 days to allow me to continue to support you. After 15 days, this thread will be transitioned to community support. The community users will be able to help you on your follow-up questions.

If you happened to close this thread you might receive a survey. If you think you would rank your support experience less than 10 out of 10, please allow me to correct it before closing or if the problem can’t be corrected, please let me know the cause so that I may improve your future service experience.

Regards

Jingyang, Teh