Intel® FPGA University Program
University Program Material, Education Boards, and Laboratory Exercises
1196 Discussions

DE2-70 Default help

Altera_Forum
Honored Contributor II
‎01-20-2011 06:18 AM
1,021 Views

Hey guys im new at this. i recently bought a DE2-70 board but whenever i start the board it doesnt do that default demo thing (where the lights flash, the numbers change, lcd says welcome) i know its not a big deal but any idea how i can permanently load the default demo into the board? i tried setting the board to PROG and then using programmer to load it but it doesnt work (however it loads when its on RUN but it is only temporary since itll get erased when i turn it off). thanks

0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎01-20-2011 07:27 AM
253 Views

Don't over any FPGA image into EPCS. So when you witch to RUN then power up, the default image will load.

0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.