Intel® FPGA University Program
University Program Material, Education Boards, and Laboratory Exercises
1174 Discussions

Quartus 18.1 Standard Edition - Altera Cyclone V Family

Tom_BGU
Beginner
464 Views

Hello all,

I have installed Quartus 18.1 Standard Edition and the required Cyclone V files from the Intel download center. 

When I open a new project via project wizard there are no devices shown at all.

 

would appreciate any help,

Thanks in advance!

 

0 Kudos
3 Replies
Nurina
Employee
444 Views

Hi Tom,


After downloading the Cyclone V files, you need to install them on Quartus. You can refer to this Quick Start Guide for the steps you need to take, it's available on the last page: https://fpgasoftware.intel.com/static/quick_start_guide/quick_start_guide_18.1_en.pdf


I hope this resolves your problem.


Best regards,

Nurina


0 Kudos
Tom_BGU
Beginner
437 Views

Hello!

Thanks for the reply.

I have installed the Cyclone V package via the Quartus 18.1 Device Installer.

Still,  when I try to open a new project, the device list is completely empty

 

Tom

 

0 Kudos
Nurina
Employee
428 Views

Hello Tom,


Did you make sure you download the device support file for Quartus 18.1 Standard edition instead of Lite, or maybe Quartus 20.1?


An easy solution would be to reinstall the software and devices.


I hope this helps!


Cheers,

Nurina


0 Kudos
Reply