pointer with too many characters

[kooka]

I used the fortran wizard to generate some COM interfaces to autocad methods. Then the wizard generatea module with interfaces and pointers to that interfaces, the problem is that when i try to compile the output window show me some errors like this:

Error: This symbol has too many characters[IAcadSectionTypeSettings_GetIntersectionBou]

POINTER(IAcadSectionTypeSettings_GetIntersectionBoundaryDivisionLines_PTR,IAcadSectionTypeSettings_GetIntersectionBoundaryDivisionLines)

where IAcadSectionTypeSettings_GetIntersectionBoundaryDivisionLines is a function. What can I do whitout changing the name of the function, because i don't want to make errors and is an Autocad function and i thik I can't change the name.

Tanks!

[Steven_L_Intel1]

You're two characters over the 63-character limit for identifiers. The only option is to shorten the name. If you changed _PTR to _P, that would just sneak in under the wire. But this does mean some manual editing.

[kooka]

thanks steve. I only have a question. If I modify the name will the autocad function work properly?. That's because i didn't put that name, was the Fortran module wizard with the interfaces it find in the autocad to autocad methods.

[Steven_L_Intel1]

Yes - as long as you change it everywhere it appears in the module. That name is derived from the interface name but not dependent on it.

[kooka]

Thanks Steve i could solve my problem. Now I can Connect with Autocad