- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using Quartus Prime Programmer Lite edition to flash my board. I have used MAX V FPGA in my design. Till morning I was able to flash the board. Now, when i try to flash, FPGA is not getting auto-detected, it shows some pop-up like below:
Could someone please help me on this? (USB Blaster is detected in Hardware setup - On clicking on Auto Detect, FPGA is not detected). What could be the issue. I was using the same blaster till morning and everything worked good. All of a sudden, Programmer stopped detecting FPGA. I would be glad if someone could render help at the earliest.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
-Please try the JTAG chain debugger to see the JTAG chain. Send us the screenshot.
-Can you try to switch the FPGA by using another good working FPGA on the current board?
Regards,
Aiman
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Any update for this case?
Regards,
Aiman
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
We do not receive any response from you to the previous answer that I have provided. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page