I know that the old version of the Edison's firmware didn't load Arduino sketches after it rebooted. But in the latest version it still seems to be doing it, is this true? I have tried multiple times to no avail. I never could get the workaround to work, it just froze my Edison.
Could you please let us know which guide or process did you use? I guess you're talking about the adding a service that runs the Arduino sketch every time the Edison boots, but I would like to know which process was used to achieved this. In case you're using the process from this thread /thread/77945?start=0&tstart=0 https://communities.intel.com/thread/77945?start=0&tstart=0, could you tell us where in the process you're getting stuck? Were you able to complete workaround steps successfully? You also mention that the Edison freezes, does this happens at boot?