Intel® Makers
Intel® Edison, Intel® Joule™, Intel® Curie™, Intel® Galileo
Announcements
Welcome - This is a Peer-to-Peer Forum only. Intel has discontinued these products but you may find support from other customers on this Forum
9868 Discussions

Cannot run sketches

EMore7
Beginner
1,273 Views

Hi,

I have a Galileo board with Green PCB (Rev C Typical).

And I cannot run any sketches. After compile and upload I got this error in serial:

root@clanton:/sketch# root@clanton:/sketch# clloader: remote command execution requested clloader: mv -f /sketch/sketch.elf /sketch/sketch.elf.old signal- child ignore signal rxed Zmodem wait finished .. restart to look for sketch /sketch/sketch.elf file does not exist or invalid permissions Receiving: Blink.cpp.elf Bytes received: 10240/ 49184 BPS:393847 ETA 00:00[ 890.081460] ttyGS0: RX not scheduled? [ 890.085339] ttyGS0: RX not scheduled? Bytes received: 47104/ 49184 BPS:596253 ETA 00:00 Clloader: fclose: 0x95bb060 Bytes received: 49184/ 49184 BPS:578635 Zmodem wait finished .. restart to look for sketch /sketch/sketch.elf file does not exist or invalid permissions clloader waiting to receive.clloader: remote command execution requested clloader: mv Blink.cpp.elf /sketch/sketch.elf; chmod +x /sketch/sketch.elf signal- child ignore signal rxed Zmodem wait finished .. restart to look for sketch Sketch child process started, pid=01606 Starting /sketch/sketch.elf /dev/pts/0 /dev/ttyS0 sigchld signal rxed.. child pid:1606 terminated, go back to wait for command ... HUP or CHLDTERM Received, Change state to wait for command from host

Messages in Arduino IDE (looks fine):

# mv the downloaded file to /sketch/sketch.elf target_download_name="${host_file_name# */}" echo "Moving downloaded file to /sketch/sketch.elf on target" # $fixed_path/lsz.exe --escape -c "cp sketch /sketch/sketch.elf" <> $tty_port_id 1>&0 $fixed_path/lsz.exe --escape -c "mv $target_download_name /sketch/sketch.elf; chmod +x /sketch/sketch.elf" <> $tty_port_id 1>&0 Moving downloaded file to /sketch/sketch.elf on target Transfer complete

Thank you

0 Kudos
1 Solution
ADRIAN_B_Intel
Employee
162 Views

Hi,

Arduino IDE is not supported on FabC green boards.

You can use these boards as Quark X1000 development boards (Linux Level development) but the Arduino IDE support is not there hence you see errors.

Please wait for a Galileo board if you want to use the Arduino IDE.

-a

View solution in original post

1 Reply
ADRIAN_B_Intel
Employee
163 Views

Hi,

Arduino IDE is not supported on FabC green boards.

You can use these boards as Quark X1000 development boards (Linux Level development) but the Arduino IDE support is not there hence you see errors.

Please wait for a Galileo board if you want to use the Arduino IDE.

-a

View solution in original post

Reply