Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Beginner
1,248 Views

Eclipse IDE cannot search target

I just started using Intel Edison Breakout Board for personal project, and I've been following the procedure as described in loT website. However, I've encountered a problem when I was trying to establish connection from my Edison to Eclipse. The picture below is where I have problem (https://software.intel.com/en-us/blinking-an-led-with-eclipse-ide-on-the-intel-edison-board IoT - Blinking an LED with the Eclipse* IDE on the Intel® Edison board | Intel® Developer Zone this is the link to the page)

When I try to search my Edison, it doesn't show up in my target connection. I've flashed my board, and I've established a wifi connection too. Any helps would be appreciated, as I'm new to this entire process. Thanks!

2 Replies
Highlighted
Novice
15 Views

Ya..I meet the same problems now. Have you solved it?

0 Kudos
Highlighted
Novice
15 Views

Have you made a wi-fi configuration through the putty?

0 Kudos