This thread is intended for people attending the Edison Course at Fab Lab London to ask questions and each other out in preparation of the Hackathon on November 26th.
I followed the instructions to connect the Edison using a Mac. Everything was working until I couldn't open the step for Arduino IDE. The Intel website came up with an error message and suggested looking on FAQ and developer area. Couldn't find what I needed there so found instructions elsewhere on the web and tried to run the blink sketch. It attempts to upload but nothing happens.Any suggestions?
I found the answer to my question. The link on the Intel website has not been updated yet. If anyone else reaches that page and has the same problem, the link should be https://software.intel.com/en-us/get-started-arduino-blink# Next_Steps https://software.intel.com/en-us/get-started-arduino-blink# Next_Steps