Intel® Makers
Intel® Edison, Intel® Joule™, Intel® Curie™, Intel® Galileo
Announcements
Welcome - This is a Peer-to-Peer Forum only. Intel has discontinued these products but you may find support from other customers on this Forum
9881 Discussions

Edison (Ubilinux) doesn't boot after change "/etc/resolv.conf"

PSilv4
Beginner
1,406 Views

Hi guys,

I have a Edison with Ubilinux (version 150309) and I was trying add a new route to internet putting the "nameserver 8.8.8.8" inside the file "/etc/resolv.conf". After that, I reboot the Edison and the Ubilinux doesn't boot more, rebooting always after show the message: "[ ok ] Starting enhanced syslogd : rsyslogd.".

Did someone has this problem and know how resolve this?

Another question is, do you know if has new version of Ublinux to Intel Edison?

Thank you!

Hugs

0 Kudos
1 Solution
Pablo_M_Intel
Employee
183 Views

Hi pvas,

To get support for the Ubilinux image you should contact the EmuTexLabs support team. We only support the Yocto image, so I believe you'll be get a more accurate answer in their forums, http://www.emutexlabs.com/forum/index http://www.emutexlabs.com/forum/index.

Regards,

Pablo

View solution in original post

2 Replies
Pablo_M_Intel
Employee
184 Views

Hi pvas,

To get support for the Ubilinux image you should contact the EmuTexLabs support team. We only support the Yocto image, so I believe you'll be get a more accurate answer in their forums, http://www.emutexlabs.com/forum/index http://www.emutexlabs.com/forum/index.

Regards,

Pablo

PSilv4
Beginner
183 Views

Hi Pablo,

Thank you for your answer. I'll put this question there.

Regards,

Paulo

Reply