Intel® Makers
Intel® Edison, Intel® Joule™, Intel® Curie™, Intel® Galileo
Welcome - This is a Peer-to-Peer Forum only. Intel has discontinued these products but you may find support from other customers on this Forum
9868 Discussions

Intel Curie BLE- AT commands

Community Manager

Hi everyone, I would like to apply the Intel Curie BLE Module that equipt the Arduino 101 board to comunicate towards a dongle

The problem is that the dongle operates by means AT Commands that think are not supported by the Intel Curie Module (someone can confirm this, please)

Someone can suggest me how is possible to match the Arduino Curie Module BLE with a device operating with AT Commands?

Thank you in advance,

Best regards

0 Kudos
1 Reply
Community Manager

Hello Pierluca87,



Thank you for your interest in the Intel® Curie™ Board.



This type of inquiries are out of the scope of this technical support team, since we focus on issues related to the Curie module itself.



The adequate assistance is provided by the Arduino community, and I saw that you already posted your question there (



As stated in this article, you'll probably need to include the BLESerial.h library (



Please note that in the comment section of that article, Martin mentions the following:



You can only communicate by serial using the monitor or plotter (like send AT commands and read values sent from other devices).



If you have any update or another question related to the Curie module itself, don't hesitate to contact us.



Have a nice day.





Andres V.