- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hi ,
I made a simple project with C1000 MCU , It powered by 1.8V regulated via VCC_HOST_1P8 and I used USB for programming , I want to use UART only, but it did't work
Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hi ,
Can you elaborate the issue you are seeing with the UART ?
- Michelle.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hi,
Circuit didn't work , I think the problem with my pcb
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hi ,
Have a look at the Platform Design Guide https://www.intel.com/content/dam/www/public/us/en/documents/design-guides/quark-c1000-platform-desi... https://www.intel.com/content/dam/www/public/us/en/documents/design-guides/quark-c1000-platform-desi...
There are some guidelines in there for UART Pin Termination...
- Michelle.

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page