Community
cancel
Showing results for 
Search instead for 
Did you mean: 
DHern7
Beginner
981 Views

Starting Fresh

Jump to solution

Is there a way that I can start completely fresh with the intel Edison arduino breakout? Ive gone throu the whole etting started process and even blinked the LED in Arduino...A couple monts back. I want to go throu te whole process aain but ow do I in a way factory reset as in fres from the box.

1 Solution
Diego_V_Intel
Employee
90 Views

Hello Roentgenium111,

A "factory reset" would be to re-flash the Edison module. You can flash the Yocto image again using the Flash Tool Lite. You can download it from the following site: https://software.intel.com/en-us/iot/hardware/edison/downloads IoT - Intel® Edison Board Download | Intel® Developer Zone. The Yocto image can be downloaded from the following link: http://downloadmirror.intel.com/25028/eng/edison-image-ww25.5-15.zip http://downloadmirror.intel.com/25028/eng/edison-image-ww25.5-15.zip

Regards,

Diego.

View solution in original post

2 Replies
DHern7
Beginner
90 Views

My G and H arent the most functional.

Diego_V_Intel
Employee
91 Views

Hello Roentgenium111,

A "factory reset" would be to re-flash the Edison module. You can flash the Yocto image again using the Flash Tool Lite. You can download it from the following site: https://software.intel.com/en-us/iot/hardware/edison/downloads IoT - Intel® Edison Board Download | Intel® Developer Zone. The Yocto image can be downloaded from the following link: http://downloadmirror.intel.com/25028/eng/edison-image-ww25.5-15.zip http://downloadmirror.intel.com/25028/eng/edison-image-ww25.5-15.zip

Regards,

Diego.

View solution in original post

Reply