Intel® Makers
Intel® Edison, Intel® Joule™, Intel® Curie™, Intel® Galileo
Announcements
Welcome - This is a Peer-to-Peer Forum only. Intel has discontinued these products but you may find support from other customers on this Forum
9881 Discussions

Tuchuck Board add jumper selection for GPIO to allow for 3.3v pullups, or 5 volt pullups

FGold
New Contributor II
1,011 Views

The Tuchuck board GPIO are 1.8v for J12 and J13.

To interface GPIOs to currently available shields/hats/peripheral boards pullup resistors need to be added to the hardware, to obtaing the typically 5v, or 3.3v available on the peripheral board,

The Tuchuck board does not currently allow this capability. Additional resistors, and jumpers should be designed into the tuchuck schema.

0 Kudos
1 Reply
idata
Community Manager
128 Views

Hello floydg,

 

 

Thank you for interest in the Intel® Joule™ Products.

 

 

I want you to know that we take this kind of requests very seriously, I assure you that your feedback will be send to the corresponding team for further analysis.

 

 

Thank you for sharing your experience.

 

 

Regards,

 

Andres V.
Reply