Hi,
Below is my setup
I have connected button sensor to D2 port and Led socket sensor to D3 of Base shield v2.0 mounted on Intel galileo Gen2.
Now I want to read from D2 and write to D3 from sysfs entry.
Kindly help with gpio mappings and config settings.
Looking forward for reply ASAP.
Regards,
Shreeharsha I
Link Copied
Hello shreeharsha,
The pin configuration for Galileo Gen2 can be checked in the following site: http://www.emutexlabs.com/?option=com_content&view=article&id=203:getting-started-with-intel-galileo... EmutexLabs
There is a table with the IOs and their respective GPIOs, and a description about how to configure them as well. You will find it very useful.
Regards,
Diego.
Hello shreeharsha,
The pin configuration for Galileo Gen2 can be checked in the following site: http://www.emutexlabs.com/?option=com_content&view=article&id=203:getting-started-with-intel-galileo... EmutexLabs
There is a table with the IOs and their respective GPIOs, and a description about how to configure them as well. You will find it very useful.
Regards,
Diego.
For more complete information about compiler optimizations, see our Optimization Notice.