Intel® Makers
Intel® Edison, Intel® Joule™, Intel® Curie™, Intel® Galileo
Announcements
Welcome - This is a Peer-to-Peer Forum only. Intel has discontinued these products but you may find support from other customers on this Forum
9868 Discussions

problem with login putty

akhas1
Novice
1,400 Views

Hey!

I have a problem with my galileo board gen2, can't login because need a password although I did before several times but i don't what I did or what make this happen

the main problem is I can't type even anything unless "Enter" !!!!

To know my connecting using ethernet cable as it's worked before probably as I mentioned previous

2 Replies
Pedro_M_Intel
Employee
249 Views

Hello AhmedKhassawneh,

Are you sure that's your Galileo's IP? If your Galileo's IP is assigned through DHCP, it might have changed. You can find out your Galileo's IP easily with a simple Arduino sketch. Under loop add the next couple of lines:

...

system("ifconfig > /dev/ttyGS0");

delay(1500);

..

You should now be able to see your Galileo's IP on the Arduino IDE serial console every 1.5 seconds.

Also, are you using an SD-Card image? If this isn't the case, then SSH will not work since it is not included on the SPI image

Peter.

Carlos_M_Intel
Employee
249 Views

Hi AhmedKhassawneh,

Do you still have problems while login in Putty? Did you try with Peter's suggestions?

Regards,

Charlie.

Reply