Intel NUC 10 and CentOS 7

[NDSiouxFan]

I installed FreePBX distro with CentOS7 on an Intel NUCi5FNH and apparently there are no Ethernet drivers included with the distro. Can anyone point me to Linux drivers for this?

Thanks in advance.

[Alberto_Sykes]

NDSiouxFan, Thank you very much for your response.

In reference to your question about the Ethernet drivers for CentOS 7, just to let you know, normally the driver should get installed natively. In this case, what we can try first is to update Kernel to the latest version, then update the system and the driver should get installed.

If the problem persists after that, then you can try to install the following version of the driver from the link below:

https://www.intel.com/content/www/us/en/support/articles/000005480/network-and-i-o/ethernet-products...

Regards,

Albert R.

Intel Customer Support Technician

A Contingent Worker at Intel

[Alberto_Sykes]

NDSiouxFan, I just wanted to check if the information posted previously was useful for you and if you need further assistance on this matter?

Regards,

Albert R.

Intel Customer Support Technician

A Contingent Worker at Intel

[Alberto_Sykes]

Hello NDSiouxFan, Since I have not heard back from you, we are closing the case, but if you have any additional questions, please post them on a new thread so we can further assist you with this matter. 

Just to let you know, Linux distributions normally include all necessary drivers, so you can always get in contact directly with your Linux vendor and use their distribution resources for driver downloads and support:

https://www.intel.com/content/www/us/en/support/articles/000005499/intel-nuc.html

Regards,

Albert R.

Intel Customer Support Technician

A Contingent Worker at Intel