Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Beginner
420 Views

NUC10i7FNH Want Legacy Boot not UEFI Boot

Jump to solution

Want to install Citrix Hypervisor but end up in the black screen with blinking cursor. So in the BIOS it has to Entries UEFI and Legacy but both are greyed and UEFI is enabled. How can i change this to Legacy?

0 Kudos

Accepted Solutions
Highlighted
Super User
193 Views

disable both Secure Boot and Modern Standby.

 

Doc

 

View solution in original post

3 Replies
Highlighted
Super User
194 Views

disable both Secure Boot and Modern Standby.

 

Doc

 

View solution in original post

Highlighted
Beginner
193 Views

worked 👍 now i can boot the Citrix Hypervisor but i am stucked at the installation since no network interface card was found 👎

0 Kudos
Highlighted
Moderator
193 Views

Hi,

 

We have no drivers for Citrix* for the Intel® Ethernet Connection I219-V that is embedded in your NUC, all drivers available are here: https://downloadcenter.intel.com/product/82186/Intel-Ethernet-Connection-I219-V and we dont support Citrix* either so our resources to help you with this request are very limited.

I believe the next step is to use Citrix Driver Development Kit (DDK) that will allow you to create your own supplemental pack and for that purpose, I would recommend working directly with Citrix: https://identity.citrix.com/Utility/STS/Sign-In?ReturnUrl=%2fUtility%2fSTS%2fsaml20%2fpost-binding-r... or visit any of their forums and get help from other Citrix users.

 

I hope this helps.

 

Regards,

Ronny G

 

 

0 Kudos