Analysis & Synthesis on Quartus 19.4 fails without any error.

[HSuh01]

Hi, 

I am working on the Straix MX 10 which comes with HBM on the board.

While I am working on the synthesis of my design, I got stuck on Analysis & Synthesis stage.

I shows "x" mark on the compilation flow window, but the transcript or message window show no error.

I think it's a problem of quartus' verbosity setting what should I change to increase the tools verbosity of the transcript window?

Thank you for any input.

Best,

Hsuh

[ShengN_Intel]

Hi,

May I know your OS operating system?

Do you have enough memory ram?

Thanks,

Best Regards,

Sheng

[ShengN_Intel]

Any further update? Have your problem being resolved?

[ShengN_Intel]

Since there are no further feedback for this thread, I shall set this thread to close pending. If you still need further assistance, you are welcome reopen this thread within 20days or open a new thread, some one will be right with you.