I am working on the Straix MX 10 which comes with HBM on the board.
While I am working on the synthesis of my design, I got stuck on Analysis & Synthesis stage.
I shows "x" mark on the compilation flow window, but the transcript or message window show no error.
I think it's a problem of quartus' verbosity setting what should I change to increase the tools verbosity of the transcript window?
Thank you for any input.
Since there are no further feedback for this thread, I shall set this thread to close pending. If you still need further assistance, you are welcome reopen this thread within 20days or open a new thread, some one will be right with you.