Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
15539 Discussions

Batch mode and technology map viewer

Altera_Forum
Honored Contributor II
830 Views

I run the synthesis in a batch mode (based on 'tcl' scripts). The whole flow is launched at certain point by the TCL command: 

execute_flow -compile  

 

When I open the compiled project in GUI and try to inspect a technology map clicking technology map viewer (post-fitting) under fitter in the tasks window, Quartus re-snthesis the project. It's like it's not aware of the stage of the project, although it presents report properly.  

How to make it open the technology map of the project syntehsized earlier in the batch mode?
0 Kudos
0 Replies
Reply