Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
16556 Discussions

Confused about connections in Quartus

Anonymous
Not applicable
551 Views

I am a newbie!!

My project is to make 4 bit magnitude comparator using 2 bit magnitude comparator. I made connection but problem is that is didn't know what is the meaning of  A[3..0] the input is of 8 bit then how to make connection. I provide screen shot of the diagram.

A[3..0] and B[3..0] is used to connect with 8 bit , how to connect this please HELP!!!

If i directly connect A[3..0] and B[3..0] with the inputs then error occurs. SEE IN SCREEN SHOT.

Hope you understand my concern and help me in this case.

0 Kudos
3 Replies
SyafieqS
Moderator
528 Views

Hi Chouhan,


I can see you did not connect the node or bus to a source signal. To do so, you can label/name the wire A and B for first above 4 and first below 4 respectively. Then, recompile it.


Thanks,

Regards


0 Kudos
Anonymous
Not applicable
522 Views
0 Kudos
SyafieqS
Moderator
493 Views

Hi Chouhan,


Any update regarding this issue?


0 Kudos
Reply