Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
17252 Discussions

Entity assignment

Altera_Forum
Honored Contributor II
‎02-14-2011 09:39 PM
1,205 Views

Newbie. I would like to assign an entity to a specific LAB. When I tried this using Chip Planner, by dragging the entity to a new LAB, the new assignment shows up in my schematic with the LAB label attached to the entity. But post-compile, the new assignment is not recognized in the Chip Planner, but instead remains in its original (previous) location. What am I doing wrong? 

 

Thanks for your help, 

 

Owkmann
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎02-14-2011 10:48 PM
495 Views

Also, I get these errors from Quartus after attempting to make an assignment: 

 

Warning: Ignoring location assignments for the following nodes because they are being preserved at their previous Fitter locations. 

Warning: Node inst40 will be placed according to its previous placement at LCCOMB_X49_Y13_N2 and ignore the location assignment to LCCOMB_X49_Y22_N2  

Warning: Node inst17 will be placed according to its previous placement at LCFF_X49_Y13_N3 and ignore the location assignment to LCFF_X49_Y22_N3  

 

Any ideas? 

 

Thanks, 

 

Owkmann
0 Kudos
Copy link
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.