- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
quartus 20.2 build 50.60/11/2020
Firmware revision 0x000a on channel 0 is not supported when loading e-tile toolkit.
E-tile parameter change to 10G implementation caused e-tile toolkit to not load.
Hundreds of e-tile example designs were built and loaded successfully until this configuration.
Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2 Warning found in EHIP IP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
- Can you share full screenshot of the error message ?
- When you mentioned E-tile toolkit, are you referring to transceiver toolkit ?
- May I know are you using Intel FPGA dev kit board or your own custom board ?
- Your quartus design FPGA OPN shown you are using ES silicon device - VGS1
- ES silicon device is not meant to support all feature in long run.
- Do you have S10 production device to try out ?
- I noticed you have some warning in EHIP IP setting. Can you clean up the warning and then retry toolkit ?
- Can you also try out toolkit with latest Quartus version v20.4. Compile design with v20.4 and open toolkit in v20.4
Thanks.
Regards,
dlim
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI,
I am setting this case to closure since I haven't hear back from you for more than 2 weeks.
Hopefully things is working on your side.
Feel free to post new forum thread if you still required help in future.
Thanks.
Regards,
Deshi
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page