- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
You can select the mode required for stepper motor like (full step, half step & micro step)? understand the specification of motor & GPIO. refer the link https://alteraforum.com/forum/showthread.php?t=29637 https://alteraforum.com/forum/showthread.php?t=43814 http://www.eewiki.net/pages/viewpage.action?pageid=4096117#steppingmotorcontrol%28withvhdl%29-introduction Best Regards, Anand Raj Shankar (This message was posted on behalf of Intel Corporation)
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page