Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
15771 Discussions

Hi, Im trying to make testbench but i get this error (vsim-7) Failed to open readmem

antonto
Novice
536 Views

** Warning: (vsim-7) Failed to open readmem file "D:/altera askhseis/tbtest999/stimulus.tv" in read mode.
# No such file or directory. (errno = ENOENT) : D:/altera askhseis/tbtest999/tbtest.sv(23)

 

This is the full message that i get....I have been searching for a solution but couldn't find any. Some help would be great!! Thanks in advance.

0 Kudos
5 Replies
sstrell
Honored Contributor III
523 Views

Why is there a space in your file path?  Modelsim and pretty much all tools don't like spaces in paths.

SyafieqS
Moderator
501 Views

Angel,


Your path seem has space which would make the tool not able to navigate to it. Rename the path without space.


antonto
Novice
481 Views

@SyafieqS  @sstrell  Thanks for replying! I changed the path and now im getting this error 

** Error: (vsim-3033) topModule.svo(53678): Instantiation of 'fiftyfivenm_adcblock' failed. The design unit was not found.
# Time: 0 ps Iteration: 0 Instance: /topModule File: topModule.svo
# Searched libraries:
# D:/fpga19.1/modelsim_ase/altera/verilog/altera_mf
# D:/alteraAsk/topModule/simulation/modelsim/gate_work


Any ideas on what to do? 

sstrell
Honored Contributor III
473 Views
SyafieqS
Moderator
400 Views

Angel,


Are you able to solve the simulation issue? 

See if below discussion could be helpful.

https://community.intel.com/t5/Intel-Quartus-Prime-Software/Problems-simulating-ADC-in-DE10-Lite-boa...



Reply