- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have set Allow trigger condition changes only which will allow me to change trigger condition changes after compilation.
Since I want to change the trigger condition dynamically, I am confused with the BASIC AND and Don't care options. Can anyone help me with this?
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Refer below link
https://www.youtube.com/watch?v=vhkzxCEXuaA
https://www.youtube.com/watch?v=xRJRC1B_oDw
Let me know if this has helped resolve the issue you are facing or if you need any further assistance.
Best Regards,
Anand Raj Shankar
(This message was posted on behalf of Intel Corporation)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Anand,
I have gone through the links. The video does not give a explanation of Basic AND and don't care combination.
Also, the video every time has Allow all changes in the signal tap. When this option, is set we have to recompile the entire design every time we change the control on the trigger condition.
To avoid this, we have to select the option, Allow trigger condition changes only. This allows us to change the trigger condition control at any time. This doesn't require compilation unless you bring in a new signal to tap.
I will try this out as I don't have a clear picture now and post the findings.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have tried it and this option works.
When choosing multiple signals to tap, we can set it to Allow trigger condition changes and most of the signals don't care. This will allow us to capture based on any of the trigger condition. This can be changed once the compilation is complete.
My example;Signal tap on AXI signals
I selected valid and ready of all channels as trigger condition. Also, since I know both valid and ready should be high for AXI transfer, I selected BASIC AND operation. During tapping i choose which set of valid and ready I want to capture.

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page