Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
16556 Discussions

Interface Planner, why no assignments after Initialization of Interface Planner

SOkte
Novice
758 Views

In the Interface planner I see a report in the Reports Tab

In the Interface planner I do not see assignments in the Assignments Tab,

but I do have assignments that can be seen from Assignment Editor

2 Replies
sstrell
Honored Contributor III
302 Views

What's the "125" filter you have enabled on the Assignments tab?

 

I'm not sure if I/O standard assignments would appear in the Assignments tab of Interface Planner, only location assignments. Try adding a single location assignment in the Pin Planner, then go back into Interface Planner. See if the location assignment you created appears.

 

#iwork4intel

0 Kudos
Vicky1
Employee
302 Views
Hi Serkan, Either you clear that "125" filter using "Clear option" or reopen the Interface planner & Initialize the Interface Planner. Regards, Vikas
0 Kudos
Reply