Programming Using Command Line

Intel® Quartus® Prime Software

Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)

Programming Using Command Line

531 Views

HI,

I am using the following command to program the CPLD from command line

start quartus_pgm -z --mode=JTAG --operation="p;C:\Test Firmware\CPLD_U1.pof@1"

It runs the quartus_pgm and exits on success or failure. I am unable to view the output as it quits immediately.

Can anyone suggest me a way to look if the programming was successful or not and how to read the output of quartus_pgm

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.