- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I run Quartus Prime 20.1 Lite from Ubuntu 20.04 LTS and tried to program DE1-SoC board, but Quartus cannot recognize the board. "Hardware Setup..." shows "No Hardware" while the board is hooked via USB cable.
Do I miss any settings?
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Need some settings as described in this link:
https://rocketboards.org/foswiki/Documentation/UsingUSBBlasterUnderLinux
After such configure, the board is recognized.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Need some settings as described in this link:
https://rocketboards.org/foswiki/Documentation/UsingUSBBlasterUnderLinux
After such configure, the board is recognized.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
Welcome to INTEL forum. Thanks for your update. For further information regarding the DE1 SOC fpga Board. It would be better if you could contact Terasic for enquiry related to Terasic board. https://www.terasic.com.tw/cgi-bin/page/archive.pl?Language=English&CategoryNo=12&No=20
Please accept my apologies for not being able to assist you fully as this is out of my expertise.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page