Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
14961 Discussions

Quartus Prime (Lite Edition): timing violation signals on Netlist

Altera_Forum
Honored Contributor I
798 Views

How can I look signals out that cause timing violations (setup/hold) on Netlist. 

If there are some timing violations on some signals, I can put FFs between those signals to prevent setup/hold timing violations. 

My question is how can I figure it out where is the right place to put FFs? (in Quartus Prime) 

 

Thanks.
0 Kudos
1 Reply
Altera_Forum
Honored Contributor I
86 Views

Use the Timing Analyzer (aka TimeQuest). From the Quartus Compilation report in the Timing Analyzer folder, right-click the clock domain(s) in the summary reports that are failing timing and select Report Timing. This will create a detailed timing report in the timing analyzer. You can then right-click a failing timing path and cross-probe to the Chip Planner or the Technology Map Viewer to get more detail about the failing path(s).

Reply