Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
16597 Discussions

Remove "unknown" pins in the Pin Planner

Altera_Forum
Honored Contributor II
‎01-17-2017 06:16 PM
3,726 Views

Hello, 

 

Does exist some option that allows to remove all "unknown" pins in the Pin Planner? 

Actually after removing a set of signal (e.g. bus) in the top unit port declaration, I need to remove concerned signals step-by-step (and with confirmation). 

Quite annoying ... 

Thanks
0 Kudos

Link Copied

2 Replies
Altera_Forum
Honored Contributor II
‎01-17-2017 09:05 PM
2,058 Views

Just shift or control click them to select them then delete.

0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎01-17-2017 11:30 PM
2,058 Views

As I remember, it doesn't work just in one time: removing of a particular pin requires confirmation. 

I believed that does exists some dedicated option ... something like "Remove unknown pins assignment".
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.