Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Novice
106 Views

Voltage indication incorrect in timing analyzer doc

0 Kudos
13 Replies
Novice
104 Views

Re: Voltage indication incorrect in timing analyzer doc

Well, I see that in the timing analyzer of arria 10 it is 900 mV for all cases.

So I guess this is the nominal voltage and that the doc should not mention low or high voltage in that case.

doc should just mention that there are different processes (slow/fast) and temp (and not mention voltage in the table).

0 Kudos
Highlighted
95 Views

Re: Voltage indication incorrect in timing analyzer doc

Hi,

Table2 explains the general interpretation of different operating conditions. It is not specifically for Arria devices.

 

Thanks.

Best regards,

KhaiY

0 Kudos
Highlighted
Novice
92 Views

Re: Voltage indication incorrect in timing analyzer doc

I know it is general,

but my remark still applies,

the table shows different corners for process and temperature,

but not for voltage variation, as they are the same.

 

0 Kudos
Highlighted
83 Views

Re: Voltage indication incorrect in timing analyzer doc

Hi,

You may contact our documentation team by clicking on the send feedback in the document. 

Capture.PNG

Thanks.

Best regards,

KhaiY

 

 

Tags (1)
0 Kudos
Highlighted
76 Views

Re: Voltage indication incorrect in timing analyzer doc

Hi,

Is there anything else I can help you with?

Thanks.

Best regards,

KhaiY

0 Kudos
Highlighted
Novice
72 Views

Re: Voltage indication incorrect in timing analyzer doc


Can you contact them (point to this topic?).

Next time I will use the feedback.

0 Kudos
Highlighted
66 Views

Re: Voltage indication incorrect in timing analyzer doc

Hi,

I found a KDB that explains about this.

https://www.intel.com/content/www/us/en/programmable/support/support-resources/knowledge-base/soluti...

The timing models used by the software are named using the nominal Vcc voltage, not the maximum and minimum supported Vcc operating conditions.

Thanks.

Best regards,

KhaiY

0 Kudos
Highlighted
Novice
63 Views

Re: Voltage indication incorrect in timing analyzer doc

mmm, Why are the timing analysis figure not showing 870mV for slow and 930 mV for fast model in the quartus gui?

0 Kudos
Highlighted
60 Views

Re: Voltage indication incorrect in timing analyzer doc

Hi,

Every device has different supported Vcc operating conditions. As mentioned earlier, the table is a general interpretation of different operating conditions. it is not device specific. The note (1) in the table states that customer has to refer to the applicable device Handbook for Vcc value.

Thanks.

 Best regards,

KhaiY

0 Kudos
Highlighted
Novice
49 Views

Re: Voltage indication incorrect in timing analyzer doc

I mentionned under quartus timing analyzer GUI,

Quartus  knows which FPGA is being used,

so why is it not mentionning the proper voltage?

 

0 Kudos
Highlighted
17 Views

Re:Voltage indication incorrect in timing analyzer...

Hi,


I understand your concern. I have filed a case to our engineering for enhancement. Thanks for providing feedback to us.


Best regards,

KhaiY


0 Kudos
Highlighted
Novice
11 Views

Re: Re:Voltage indication incorrect in timing analyzer...

Thanks!

Tags (1)
0 Kudos
Highlighted
9 Views

Re:Voltage indication incorrect in timing analyzer...

Hi,


Since your feedback has been channeled, I now transition this thread to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.


Best regards,

KhaiY


0 Kudos