- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I need to re-use an old design and show I can recompile,place and route the old code. The design was produced under Max plus II V10.2, I have the parallel port dongle and a copy of Max Plus II 10.2. The issue is getting Maxplus II to see the dongle and also producing the licence file. Any pointers on both would be appreciated. ThanksLink Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Wow, if it's HDL code, can't you just bring it in to Quartus instead?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
--- Quote Start --- Wow, if it's HDL code, can't you just bring it in to Quartus instead? --- Quote End --- Does Quartus do Max9000?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
If you can send me your project, I can try to compile it and in case of success we could continue our discussion )
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page