Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
17054 Discussions

error detection crc

Altera_Forum
Honored Contributor II
‎06-13-2016 11:52 AM
1,201 Views

Hi , 

 

For SEU mitigation in Stratix iv GX device, I enabled ''Enable error detection CRC" from Device and Pin Options in Quartus II 13.1. But while synthesis got  

 

the error message that " Error(21216): Cannot enable error detection cyclic redundancy check without instantiating the ALTERA_CRCERROR_VERIFY  

 

megafunction ". After instantiating the IP also getting the same error message while synthesis.  

 

 

Any leads would be appreciated , links to documentation about the megafunction will also be helpful. 

 

Thanks
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.