- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
After reprogramming the fpga on a Cyclone 5 SOC, I cannot seem to find the device anymore with the following error:
MMD INFO : [acl0] HPS-to-FPGA read test failed, read 0x2 after 1 attempts ERROR: CL_DEVICE_NOT_FOUND
However this was a very minor change to the design and it appears if we put it through the full boot process the driver is fine. It also occurs when I'm trying a new aocx file with opencl.
Diagnostic repeats this error.
Reprogramming with original .rbf file does not restore it to working condition.
Ideas why??
Quartus environment version 18.1.
Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
May I know how do you update the rbf file? Could you provide the full log file for your HPS booting?

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page