How can I use weak pull-ups on HPS pins for SD card?

Intel® SoC FPGA Embedded Development Suite

Support for SoC FPGA Software Development, SoC FPGA HPS Architecture, HPS SoC Boot and Configuration, Operating Systems

How can I use weak pull-ups on HPS pins for SD card?

540 Views

I enabled weak pull-ups for the HPS pins SDMMC_D0..D3 and SDMMC_CMD in the assignment editor of Quartus. With the new generated handoff files I built a new preloader for the hps. But I don't see any influence on the SD card pins by the pull-ups.

Did I something wrong?

I use a Cyclone V SX device with a connected SD card to the SDMMC interface.

Link Copied

0 Replies

Community support is provided Monday to Friday. Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.