- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I was trying to setup the debugging option By using Intel System Debugger NDA.
But in vain.
The connection seems to be failing. I have attached the image of the same. Please guide me on how to proceed.
Also in the Intel FIT, it says logging failed. could not open fit.log.
From where do we get fit.log file. Is there a detailed document on how to get started with this DCI debugger? Like end-end detail.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Niyathi, It does seem like the DCI settings have not been enabled correctly so you are seeing those errors as the ISD cannot detect/see the target.
For DCI document please refer to RDC Doc number 571747 or 646201. You will have access to these if you have NDA with Intel - if you do not have access please contact your Account Representative.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Niyathi, we have contacted you privately with regards to your query. Please check your inbox for further updates on this issue.
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page