- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I installed System Studio 2018.1 and am trying to connect via DCI to a Gigabyte Brix board with a skylake i3-6100 that has the DCI port enabled. The DCI device shows up. However in the DAL configConsole there seem to be no target for Skylake + DCI, I'd expect SKL_SPT_DCI_ReferenceSettings however that is gone. Is there some other new way to connect?
Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
ISS 2018 is a little bit different from ISS 2017 on the target configuration.
Please refer to the guide here.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for the link.

Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page