- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
I have a customer running 4 VLANs, all VLANs running without firewall, we have L3 VLAN routing enable, all machines can access in each others (20 machines by VLANs).
Intel Unite (SMB Mode) HUB is installed on VLAN 10, machines located on VLAN 20, 30 and 40 can not connect to the HUB, only machines on VLAN 10 can.
Is there a way to configure serverconfig.xml file on a client side do specify the IP address of the HUB on VLAN 10?
HUB System:
Intel NUC 5i5MYHE
Windows 10 Enterprise 1067
Intel Unite 3.1 HUB and Client
BIOS MYi50035
Thanks
Marcio
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hello Chaborel,
Thank you for joining the Intel® Unite™ app community.
Please let me review your inquiry.
Regards,
Amy C.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
/thread/114681 Chaborel, I have sent a private message, please check your inbox.
Regards,
Amy C.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
/thread/114681 Chaborel, thanks.
I was unable to find your private message, could you please re-sent it?
Regards,
Amy C.

- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page