Schematic for RealSense interposer?

[rtsen3]

When you remove the case of the R200 you find a small metal enclosure holding the cameras. Nine conductors connect the cameras to an interposer board that expands the connection to a Micro USB 3 B socket. I would like the schematic and BOM of the interposer including the name of the connector and socket. If no one can provide a schematic and BOM, I would also appreciate the name of the pictured connector and socket. Thanks for any help!

[ABulz]

Hi rtsengMIT,

The cable and connector are 10-pin LVDS like the ones from I-PEX. I would appreciate the schematic too, particularly for the SR300. The R200 and SR300 have different interposers.

Good luck!

Adrian

[rtsen3]

Thanks! Can you send me a link to the part? I couldn't find it on the I-PEX website.

We may reverse engineer the schematic - it's not very complex. Hopefully someone responds, but if not I'll send it to you if we do it... Thanks!

/Ryan

[ABulz]

I'm fairly sure it's 20347-310E-12R for the smt cable receptacle, but someone should double check. This is the source page: https://www.i-pex.com/Products/detail/83# ! https://www.i-pex.com/Products/detail/83# !

[idata]

Hi RtsengMIT,

Thanks, Bulzacki for the help on this; at this point I would recommend you to post on our Intel® RealSense™ Technology Forum, to get further assistance. Intel® Developer Zone Forum, Intel® RealSense™ Technologyhttps://software.intel.com/en-us/forums/realsense https://software.intel.com/en-us/forums/realsense Regards,Hellen.