- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using the 20100621 distribution. Because I wanted a no-MMU kernel, I switched to the test-nios2 branches under linux-2.6 and uClinux-dist. This allowed me to successfully make and run a zImage on my board (DE2-115). Following the instructions, I then did ./update in nios2-linux. After that make complains that the assembler doesn't understand the initda instruction.
There was a suggestion elsewhere on the forum that this means that the toolchain assembler is old. I'm using the no-MMU toolchain nios2gcc-20080203.tar.bz2. Can I find a newer no-MMU toolchain? Should I be using a different distribution than 20100621? Should I re-install 20100621 and just skip the update? Thanks, D.W. LynnLink Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page