Nios® II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
Announcements
Intel Support hours are Monday-Fridays, 8am-5pm PST, except Holidays. Thanks to our community members who provide support during our down time or before we get to your questions. We appreciate you!

Need Forum Guidance? Click here
Search our FPGA Knowledge Articles here.
12455 Discussions

How to use JTAG UART with normal UART in a Qsys System

Altera_Forum
Honored Contributor II
1,156 Views

I have included a JTAG UART and a normal UART into my system. The JTAG UART shall be eventually removed but must be used for the time being. As far as I understand, I should merely goto the BSP editor settings and choose which of the two are to be used for stdin, stdout and stderr. 

 

Now, basically when I choose the uart_0 in BSP editor and try to run my design I get the this message: 

"The expected Stdout device name does not match the selected target byte stream device" 

 

I have explicitly select uart_0. What does this message mean then when it says "expected Stdout device"?
0 Kudos
0 Replies
Reply