- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Anyone knows how to fill ddr controller timing parameters from the datasheet?
Specifically i need K4H561638N-LCC parameters, I think they are similar to the K4H561638F-TCC parameteres. Have I need to use the min time for the parameters? Many thanks. ifdmLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There should be different sets of timing numbers depending on the frequency. If you take the conservative "loose" approach (choose highest timing values) the interface will continue to work but it might not give you the best performance possible. You could make different configurations for different clock frequencies while you are developing in case you don't have your memory clock speed set in stone yet.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page