NIOS II Code Edits Not Working

Nios® V/II Embedded Design Suite (EDS)

Support for Embedded Development Tools, Processors (SoCs and Nios® V/II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++

NIOS II Code Edits Not Working

1,197 Views

Hi guys,

I've been developing a Quartus Project using the University Program USB Controller., and NIOS II on a Cyclone II DE2. I've also developed a C program which allows the controller to be used with a mouse, using the NIOS II Software Build Tools for Eclipse. Everything was running just fine, but now when I try to edit and change the code, these changes don't correspond when I run the .elf on the board. No matter what changes I make in the code, when I run as NIOS Hardware, it still just runs the old version of the code. I'm not sure if its an issue with my project settings, or if my .elf isn't updating correctly or a problem with my makefile.

Any help would really be appreciated, thanks!

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.