- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I have a problem with the Nios II flash programmer. I created a project with the Quartus 10 SOPC builder starting from the reference design, triple-speed Ethernet. With Quartus 10 could program the nios. Moving to version 11 I have the following problem with the NIOS II flash programmer Erase failed at offset 800000 Leaving target processor paused Error code: 1 for command ... I'm using the STRATIX IV - EP4SGX230KF40C2 ThanksLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11.0的USB-Blaster驱动有问题,换以前的版本即可。
The driver of usb-blaster v11.0 can not work normally, try an old version to fix the problem.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page