Nios® II Embedded Design Suite (EDS)
Support for Embedded Development Tools, Processors (SoCs and Nios® II processor), Embedded Development Suites (EDSs), Boot and Configuration, Operating Systems, C and C++
12475 Discussions

PCIe Base Address Register detection issue during Boot Process

Altera_Forum
Honored Contributor II
848 Views

Hi, 

 

I connected BAR2 to the ddr controller in the Altera's PCIe dma ddr reference design for Stratix V board. It compiled successfully. But when it download and after scan & found the pcie system, the lspci -x command, showing the same BAR address for BAR0 and BAR2!!. Why? 

 

Regards, 

Firoz
0 Kudos
1 Reply
Altera_Forum
Honored Contributor II
152 Views

Hello, 

sorry I do not have the answer for your problem yet, but seems that we are trying to run the same reference design and I'm having a problem too. 

 

I have compiled the s5 GX design ( http://www.alterawiki.com/wiki/reference_design_-_stratix_v_avmm_dma ) loaded it in the board, and rebooted the computer. I get the following errors: 

 

1. lspci command does not return anything related to altera. 

 

2. furthermore, when I try to ./install, in drivers and software fold, I get an error sayng that "altera_dma" has not been found in \proc\devices 

 

I guess error 2 is a consequense from error 1. 

 

So, could anyone help me? 

 

regards
Reply