Prob niosII

[Altera_Forum]

hello, 

I have this problem when  i run my code under NiosII using cable "usb-blaster [usb-0]", device 1, instance 0x00 pausing target processor: not responding. resetting and trying again: failed leaving target processor paused  regards

[Altera_Forum]

Many things could cause this.... Have you checked that you have: 

 

1. Programmed the FPGA with the hardware your software is based upon 
2. Checked that clock and reset are properly connected. 

  Beyond that...this is a _very_ common issue and you'll find lots of other posts with additional suggestions of what to try.  Cheers,  slacker

[Altera_Forum]

i try to verifie the that clock and reset are properly connected. but  

i don't resolve the problem  have it someone can help me? regards

[Altera_Forum]

Is this a problem related to a new board or to a specific project. 

I mean, can you correctly load a different design on this same board?  Are you sure the fpga has been correctly configured before you try loading Nios software?